Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
/Page-603002.png)
-
Position crankshaft to top dead center No. 3 cylinder. Mark on toothed belt guard -A- must align with notch on belt pulley-B.
-
Check position of camshaft sprockets. Larger holes in securing plate -arrows- must align opposite one another on inside.
Note: If the larger are positioned to the outside, the crankshaft must be turned one revolution further.
-
Remove sealing plugs from cylinder block, left. Crankshaft TDC drilling must be visible (or be able to be felt) in sealing plug hole.
-
Screw clamping bolt 3242 into hole so that crankshaft is secured against turning.
-
Remove tensioner for ribbed V-belt.
-
Remove center and right-hand toothed belt guards.
-
Mark direction of rotation of toothed belt.
