Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Rear Door Latch: Service and Repair
Door Lock, Removing and Installing
Door Lock, Removing And Installing
Window regulator, door lock and loudspeaker are secured to assembly carrier.
Door lock can only be removed in conjunction with assembly carrier.
Assembly carrier can only be removed when door window is removed from window regulator. For this purpose, door window must be lowered to height
of installation hole in assembly carrier and spreader pins must be removed.
If it is not possible to lower door window by electrical window regulator, first exact cause of malfunction must be determined.
To do so, using Scan Tool (ST) V.A.G 1551, check DTC Memory of comfort system (address word 46): Repair Manual, Body On Board Diagnostic,
Repair Group 01; Comfort system; checking DTC memory.
If there is a malfunction, proceed according to description: and .
Removing
All vehicles
-
Remove rear door trim.
-
Remove housing:
-
Remove cap - 1 -.
Vehicles with electrical window regulators
-
Remove bolts - 1 - (4 X).
-
Remove housing - 2 - from window regulator motor.
Bosch window regulators