Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Slide door window upward and secure (e.g. using adhesive tape).
-
Disconnect harness connector - 1 -.
-
Remove bolts - arrows -.
-
Remove door seal - 1 - in area of door handle.
-
Pull door handle - 2 - in direction of arrow and hold in this position. Remove bolt - 4 - up to stop using Socket wrench T 10011. housing is
loosened by doing so.
NOTE: If bolt has been loosened too far, this may cause lock mechanism ring to loosen from mounting bracket and fall into door.
-
Remove housing - 3 - at right angle to door from door handle mounting bracket.
-
Remove upper assembly carrier from door, lift and lift out of door toward hinge side - arrow - of door.
-
Rotate assembly carrier and disconnect harness connector from door lock.