Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Removing And Installing Wiring For Shift Lock, Shift Lever Illumination And Tiptronic
Removing
-
Remove center console and extension.
-
Disconnect harness connector -1- for shift lock solenoid -N110- (item -2-) (concealed).
-
Unclip cover-3- and lift up.
-
Disconnect harness connector -4-for shift lever positions and Tiptronic in direction of arrow.
Installing
Installation is the reverse of removal.
Removing And Installing Selector Lever Handle
Removing
-
Shift selector lever into position "2."
-
Slide sleeve -1- down as far as it will go.
-
Carefully pull button -2- out of selector lever handle -3- over detent point until dimension -a- is obtained. Pull lever -4- will then be pulled out of
pull rod -5-.
^
Dimension -a- = 5 mm
^
Dimension -a- corresponds to width of connecting eye -6- on spring -7-
Note: Do not overstretch spring or pull out forcibly.
-
Simultaneously pull handle -3- off selector lever -8-.
Note: Do not damage the eye of the pull rod
Installing
-
Shift selector lever into position "2."