Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Pull out seal.
Installing
Installation is the reverse of removal, when installing note the following:
-
Always replace O-ring behind flange.
-
Drive new seal in up to stop. When doing this do not cant seal.
-
Lubricate space between sealing lip and dust lip with multi-purpose grease.
-
Drive drive shaft flange onto pinion until securing nut can be installed.
-
Clean threads on drive pinion and flange nut free of grease and coat thinly with D 000 600.
-
Install original nut and tighten to position marked.