volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Ignition system, glow plug system > < Coding engine control unit

Polo Mk3

Adapting engine control unit to electronic immobilizer
Adapting engine control unit to electronic immobilizer
Special tools and workshop equipment required
t  Fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- with diagnosis cable -V.A.G 1551/3-
Test prerequisite
l  Authorized vehicle key required.
Procedure
   
–  Remove ashtray -1-.
–  Connect fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- with diagnosis cable -V.A.G 1551/3-.
–  Switch on ignition.
–  Operate fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- taking into account the information on the display:
–  Press key 1 for “Rapid data transfer”.
–  Press keys 2 and 5 for address word “immobilizer” and confirm the input with Q key.
–  Press → key.
  N01-0367
Indicated on display:
–  Press keys 1 and 0 for the function “Adaptation” and confirm input with the Q key.
  
Rapid data transfer                 HELP
Select function XX
Indicated on display:
–  Press key 0 twice for “Channel number 0” and confirm entry with Q key.
  
Adaption                               
Feed in channel number XX
Indicated on display:
–  Confirm entry with Q key.
  
Adaption                               Q
Erase learnt values?
Indicated on display:
–  Finish adaption by pressing → key.
–  Press keys 0 and 6 for function “End output” and confirm entry with Q key.
–  Switch off ignition.
  Note
The identity of the engine control unit is read into the immobilizer control unit when next switching the ignition on.
  
Adaption                              ->
Learnt values have been cleared

Ignition system, glow plug system > < Coding engine control unit