Polo Mk3
| 4-cylinder fuel injection engine with power assisted steering, vehicles ► 04.99 |
| 1 - | Hexagon bolts |
| q | 55 Nm |
| q | With aluminium block: M10×55 mm, renew bolts (coated with sealant) |
| q | With cast iron block: M10×50 mm |
| q | Tightening sequence: upper right bolt first (item 1), then lower right bolt (item 3), and then upper and lower bolts on left (as seen looking forwards) |
| 2 - | Bracket |
| 3 - | Hexagon bolts |
| q | With aluminium block: M10×100 mm, renew bolts (coated with sealant) |
| q | With cast iron block: M10×95 mm |
| q | Tightening sequence: upper right bolt first (item 1), then lower right bolt (item 3), and then upper and lower bolts on left (as seen looking forwards) |
| 4 - | Hexagon bolts |
| q | M3×18mm |
| 5 - | Protective cap |
| 6 - | Cross-head screws |
| q | M4×25 mm |
| 7 - | Voltage regulator |
| q | Checking carbon brushes → Chapter |
| q | Removing and installing → Chapter |
| 8 - | Alternator |
| q | Prescribed torque for battery positive wire → Chapter |
| 9 - | Poly V-belt |
| q | Removing and installing → Chapter |
| q | Poly V-belt drive → Fig. |
| 10 - | Tensioning roller |
| 11 - | Hexagon bolts |
| q | M8×85 mm |
| q | 25 Nm |
