volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Running gear, axles, steering > < Servo brake - remove and install|Remove

Polo Mk4

Install
Install
The installation is performed in the reverse sequence from the removal.
   
–  Tightening torque for the hexagonal nuts -arrows- 28 Nm.
Fasten the brake pedal to the servo brake
  S47-0074
–  Hold the operating rod ball head in front of the seat and press the brake pedal towards the servo brake until the ball head coupling is heard.
–  Before installing, remove the rod completely.
  A47-0034
–  Inset the Brake pedal switch -F47 - in its respective housing and press it slightly against the brake pedal -arrow 1- and fasten by turning it (45°) to the right -arrow 2-.
–  Here, the brake pedal always remains at rest position
–  Insert the Brake pedal switch -F47- connector.
–  Check the brake light operation.
After adjusting, check whether the Brake pedal switch -F47- is at the final stop (loose position).
–  Bleed the brake system → Chapter.
06.09
  N46-10147

Running gear, axles, steering > < Servo brake - remove and install|Remove