–
| Remove mechanical distribution upper cover, head cover and vacuum pump. |
–
| Remove indented belt of command shaft and command shaft gear → Chapter, remove and install indented belt, adjust |
Note There is no need to remove pad/pulley, and lower and intermediate protection of indented belt. |
–
| Loosen gear screw of command shaft in one turn. To loosen screw, fasten command shaft gear to counter support 3036. |
Note To loosen and tighten command shaft gear never use command shaft adjustment rule 3418 or command shaft rule -T10098- as counter support! Use counter support 3036. |
|
|
|