volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Valve stem sealant - replace|Installation > < Valve stem sealant - replace

Polo Mk4

Removal
Removal
–  Remove toothed belt → Chapter.
–  Remove camshaft → Chapter.
–  Remove the rockers together with the support elements and place them on a clean surface.
–  Make sure the rockers and support elements are not mixed up.
–  Remove Spark plugs -Q-.
–  Place the piston of the respective cylinder in the „Lower Dead Centre“position.
   
–  Fasten the Device -2036- to the cylinder head with the screws used in the cylinder head cover.
–  Screw the Flexible tube -VW 653/3- or Flexible tube -VW 653/2a- to the Spark plug -Q-thread.
–  Connect the pressure hose with at least 6-bar compressed air.
–  Remove the valve springs with a Lever -VW 541/1A- and Complement for VW 541/1A and 2037 -VW 541/5- or Compressor -VW 541/50-.
  Note
Stuck valve cotters can be loosened by tapping slightly on the installation lever.
–  Remove the valve seal with the Impact puller -3364-.
  R15-10019

Valve stem sealant - replace|Installation > < Valve stem sealant - replace