Volkswagen Workshop Service and Repair Manuals

Removing wiper motor from wiper frame and installing   Caution When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed → Chapter. Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-

t  Release lever -80-200- Removing: –  Remove wiper frame together with wiper motor → Chapter.

–  Lever ball end -arrow- of linkage -1- off motor crank using release lever -80-200-.

–  Remove securing nut -1-. –  Pull motor crank -2- off wiper motor shaft. –  Unscrew securing bolts -arrows- and remove wiper motor together with control unit from wiper frame.

Installing

–  Insert wiper motor with control unit in wiper frame and secure using securing bolts -arrows-. –  Place motor crank -1- on shaft of wiper motor. Angle -a - = 7° –  Connect motor crank to shaft of wiper motor with securing nut -2-. –  Tighten threaded connections to specified torques → Chapter.

–  Press ball head -arrow- of linkage -1- onto motor crank. –  Install wiper frame together with wiper motor → Chapter.