R32 4Motion V6-3.2L (CBRA) (2008)
-
Drive new seal in as far as the stop; be sure not to distort seal.
-
Insert flange shaft.
-
Secure flange shaft with new conical head bolt and tighten to 30 Nm.
-
Install left drive axle.
-
Install left front wheel housing liner.
-
Install left wheel.
-
Replace the DSG oil and filter.
-
Install the noise insulation if necessary.
Right Flange Shaft or Stub Shaft Seal
Right Flange Shaft or Stub Shaft Seal - 02E, 6 Speed DSG A/T AWD
Special tools, testers and auxiliary items required
^
Drift Sleeve 3158
^
Torque wrench V.A.G 1331
^
Torque wrench V.A.G 1332
^
Sealing grease G 052 128 A1
^
Grease G 052 735
Removing
-
Remove right wheel.
-
Remove the noise insulation if necessary.
-
Remove right drive axle.
Vehicles with intermediate shaft
-
After removing right drive axle -A-, unscrew intermediate shaft -B- from mounting bracket -C- -arrows- and pull off from transmission stub shaft.
Continued for all vehicles
-
Place container under the transmission.