R32 4Motion V6-3.2L (CBRA) (2008)
-
Remove bolt -arrow- for stub shaft and flange shaft.
-
Pull out stub shaft and flange shaft together with spring.
-
Pry out seal with a lever.
Installing
-
Lightly oil the outer circumference of the new seal.
-
Fill half of volume between sealing lip and dust lip with sealing grease G 052 128
-
Drive new seal in as far as the stop; be sure not to distort seal.
-
Insert stub shaft or flange shaft.
-
Fasten stub shaft and flange shaft with new countersunk screw and tighten to 30 Nm.
Vehicles with intermediate shaft
-
Replace stub shaft O-ring.
-
Grease the stub shaft splines with grease G 000 100.
-
Guide the intermediate shaft -B- on the mounting bracket -C- onto the transmission stub shaft
-
Tighten the intermediate shaft on the mounting bracket to specification. -arrows-.
Continued for all vehicles
-
Install right drive axle.
-
Install right wheel.
-
Replace the DSG oil and filter.
-
Install the noise insulation if necessary.
Selector Shaft Lever Sealing Ring, Replacing