Rabbit L5-2.5L (BGQ) (2008)
-
Secure flange shaft with countersunk bolt.
-
Install drive axle -1- to flange shaft.
-
If equipped, install drive axle shield.
-
Check and fill gear oil.
-
Install noise insulation.
Tightening Specifications
Flange shaft to transmission (conical head bolt)
Two Piece Right Flange Shaft Seal and Sleeve, With Transmission Installed
Two Piece Right Flange Shaft Seal and Sleeve, with Transmission Installed - 0A4, 5 Speed M/T
Special tools, testers and auxiliary items required
^
Drip tray V.A.G 1306
^
Thrust piece T10160
^
Alignment fixture 3253/2
^
Torque wrench V.A.G 1331
Removing
-
Remove noise insulation.
-
Turn steering to right onto full lock stop.
-
If equipped, remove shield for drive axle from engine.
-
Unfasten drive axle -1- from flange shaft.
-
Tie up drive axle as high as possible. Do not damage paint on drive axle when doing so.
-
Place container under transmission and engine.
-
Place appropriate receptacle underneath transmission.