Rabbit L5-2.5L (CBUA) (2008)
-
Separate connector -1-.
-
Remove bolts -2- and -3-.
-
Remove sensor.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
Sensor left must face toward outside of vehicle.
-
After replacing, perform basic setting for headlights.
Tightening Specifications
Vehicle Level Sensor (Steel Subframe)
Vehicle Level Sensor (Rabbit, Steel Subframe)
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
Removing
-
Separate connector -1-.
-
Remove bolts -2- from lower transverse link.
-
Remove bolts -arrows- from subframe.
-
Remove Left Rear Level Control System Sensor G76.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
The Left Rear Level Control System Sensor G76 lever must point toward the outside of the vehicle.
-
After replacing, perform a headlamp basic setting Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault Finding"
function