Touareg V8-4.2L (BHX) (2004)
Power Distribution Module: Service and Repair
Vehicle Electrical System Control Module
‹› If control module is being replaced, first perform work procedure --> [ Vehicle Electrical System Control Module, Coding ] See: Testing and
Inspection/Programming and Relearning.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove lower storage compartment on driver side --> Body Interior 68 Removal and Installation.
‹› The number of multi-pin harness connectors - 1 - at Vehicle Electrical System Control Module (J519) can deviate from the illustration depending
on vehicle equipment.
-
Release locking mechanisms of multi-pin harness connectors - arrows - and disconnect multi-pin harness connectors - 1 - from Vehicle Electrical
System Control Module (J519) - 2 -.
-
Remove Vehicle Electrical System Control Module (J519) - 2 - with wires connected to rear side out of bracket.
-
Release locking mechanisms of multi-pin harness connectors - arrows - and disconnect multi-pin harness connectors - 1 - from Vehicle Electrical
System Control Module - 2 -.
-
Remove Vehicle Electrical System Control Module (J519) from vehicle.
Installing
Install in reverse order of removal.