volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing door handle > < Removing and installing door retaining strap

Up!

Removing and installing striker pin
Removing and installing striker pin
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
  W00-0427
t  Socket -3410-
  Note
The removal and installation sequence is only for the right door striker pin. The right side is similar.
Removing
Carry out following work:
  W00-0397
–  Remove bolts -2- and remove striker pin -1-.
Installing
Carry out following work:
  N57-10322
–  Position striker pin -1- on B-pillar -3- and tighten bolts -2-.
  WARNING
A bent striker pin (square U-shape) must be installed.
The U-shape of the striker pin points towards the inside of vehicle.
Specified torque for bolts -2-: 20 Nm.
–  Adjusting striker pin → Chapter
  N57-10322

Removing and installing door handle > < Removing and installing door retaining strap