| t
| Blade (commercially available) |
| t
| Glass-metal adhesive kit -D 000 703 A1- (standard interior mirror) |
| –
| Remove retaining plate from mirror base. |
| –
| Remove PUR adhesive sealant from retaining plate using a wire brush. |
| –
| Grind off the three spacer protrusions on bonding surface. To do this, use sandpaper (360/400 grain) laid on flat surface. |
| –
| Keep sanded surface clean and free of grease. |
| –
| Scrape down PUR adhesive sealant and glass/paint primer down to ceramic layer on windscreen using glass scraper. |
| –
| Clean adhesive contact area with adhesive remover -D 002 000 10- or cleaning solution -D 009 401 04-. |
WARNING | Do not damage ceramic coating. Scratches will remain permanently visible. |
|
| –
| Cut nylon mesh fabric exactly to size of retaining plate. |
Note | Wear hand protection (rubber gloves). |
| –
| Apply adhesive evenly to retaining plate. |
| –
| Place nylon mesh fabric on retaining plate. |
| –
| Dab nylon mesh fabric with tube while applying further adhesive. |
| Only 30 seconds are available from laying nylon mesh fabric on adhesive to pressing plate onto windscreen. |
| –
| Press retaining plate (do not use force) against windscreen for 15 seconds. |
| –
| Remove excess adhesive with a cloth. |
Note | Interior mirror can be installed after 15 minutes. |
|
|
|
