Volkswagen Workshop Service and Repair Manuals > Up! > Body | General body repairs, interior | Trim, noise insulation | dash panel | Removing and installing radio/navigation system blanking plate | Removing and installing blanking plate with prewiring for radio/navigation system

Removing and installing blanking plate with prewiring for radio/navigation system

Removing

–	Remove trim for air-conditioning section → Chapter

–	Using removing wedge -3409-, release radio/navigation system blanking plate -1- on right and left in vicinity of catches from mountings in dash panel.

–	Disconnect the electrical connectors depending on vehicle equipment.

–	Remove radio/navigation system blanking plate -1- from dash panel.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

–	Install in reverse order of removal. When doing this, observe the following:

–	All mountings for trim must be properly engaged in plate.

Volkswagen Workshop Service and Repair Manuals