Up!
|
Note
|
Note
|
– | Release expanding rivet -1- and remove upwards. |
– | Remove defrost duct -3- from dash panel central tube. |
– | Unclip air distributor -2- from heater and air conditioning unit and remove. |
– | Unscrew 2 bolts -1- (3.5 Nm). |
– | Unscrew 2 bolts -2- (3.5 Nm). |
– | Unscrew bolt -3- (3.5 Nm). |
Note
When installing, first install bolt -3- and then bolts -2- (3.5 Nm). |
Note
In area of nuts -2 and 3-, use a scriber to mark vertical and horizontal position of central tube in vehicle. |
– | Remove nut -2- on front passenger side (20 Nm). |
– | Unscrew nut -3- and bolt -4- on driver side (20 Nm). |
Note
Before removing, check whether all wiring harnesses have been detached from central tube -1-; detach if necessary. |
– | Release wiring harness fasteners, depending on vehicle equipment level, from central tube -1-. |
Note
|