volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Assembly overview - clutch hydraulics > < Removing and installing mounting bracket with clutch pedal but without clutch master cylinder

Up!

Removing and installing clutch master cylinder
Removing and installing clutch master cylinder
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Removing
Remove mounting bracket with clutch master cylinder → Chapter.
The figure shows installed mounting bracket with clutch master cylinder.
  W00-0427
–  Pull bearing shaft -A- for plunger/clutch master cylinder out of clutch pedal in -direction of arrow 1-.
–  Unscrew securing bolts -arrows 2- and remove clutch master cylinder from mounting bracket.
–  Remove clutch master cylinder from mounting bracket.
Installing
Install in the reverse order of removal, observing the following:
l  Always renew bearing shaft -A- (⇒ figure above).
l  Bearing shaft -A- must audibly engage in clutch pedal.
–  Test bearing shaft by tugging on it.
–  Install clutch master cylinder to mounting bracket using securing bolts -arrows 2- (⇒ figure above).
Torque setting: → Item.
Install mounting bracket with clutch master cylinder → Chapter.
  N30-10357

Assembly overview - clutch hydraulics > < Removing and installing mounting bracket with clutch pedal but without clutch master cylinder