Up!
Assembly overview - Selector cables |
Note
t | Lubricate bearing positions and sliding surfaces. |
t | Allocate grease using → Electronic parts catalogue (ETKA). |
1 - | Gear selector cable |
q | Availability → Electronic parts catalogue (ETKA) |
q | Connect to cable end-piece → Item |
q | Installation position → Chapter |
2 - | Gate selector cable |
q | Availability → Electronic parts catalogue (ETKA) |
q | Connect to cable end-piece → Item |
q | Installation position → Chapter |
3 - | Bush |
q | Availability → Electronic parts catalogue (ETKA) |
4 - | Securing clip |
q | Always renew |
q | Do not damage cables when removing |
5 - | Selector housing |
6 - | Hexagon bolt, 25 Nm |
q | Qty. 3 |
q | For cable support bracket |
7 - | Spacer |
q | Qty. 3 |
q | For cable support bracket |
8 - | Grommet |
q | Qty. 3 |
q | Cable support bracket mounting on gearbox |
9 - | Cable support bracket |
q | Availability → Electronic parts catalogue (ETKA) |
q | Remove from gearbox → Fig.. |
10 - | Cable end-piece |
q | Availability → Electronic parts catalogue (ETKA) |
q | Removing and installing → Fig. |
q | After installing, adjust selector mechanism → Chapter |
q | For gate selector cable to relay lever |
q | Remove from relay lever → Fig. |
q | Press onto relay lever → Fig. |
q | Allocation → Fig. |
11 - | Securing clip |
q | Always renew |
12 - | Cable end-piece |
q | Removing and installing → Fig. |
q | After installing, adjust selector mechanism → Chapter |
q | For gear selector cable to gearbox selector lever |
q | Allocation → Fig. |
13 - | Self-locking hexagon nut, 25 Nm |
q | Always renew |
14 - | Gearbox selector lever |
q | Availability → Electronic parts catalogue (ETKA) |
q | Can be renewed with the selector mechanism installed |
q | Grease before installing → Fig.. |
q | Installation position → Fig. |
q | Installing → Fig. |
q | After installing, adjust selector mechanism → Chapter |
15 - | Shoe |
q | Shoe and relay lever are listed as one replacement part. |
16 - | Relay lever |
q | Availability → Electronic parts catalogue (ETKA) |
q | Installation position → |
q | Grease before installing → Fig.. |
q | After installing, adjust selector mechanism → Chapter |
q | Remove and install together with cable end-piece → Fig. |
17 - | Clip |
q | Secures relay lever. |
q | Check for damage |
|
|
|
|
Cable end-piece for | Dimension „a“ |
1 - Gear selector cable to gearbox selector lever | 8.5 mm |
2. - Gate selector cable to relay lever | 10 mm |
|
|
Note
|
|
Note
|
|
|