Up!
| Assembly overview - coolant pump |
| 1 - | Camshaft housing |
| q | Removing and installing → Chapter |
| 2 - | Toothed belt |
| q | For coolant pump drive |
| q | Removing and installing → Chapter |
| 3 - | Camshaft pulley |
| q | For coolant pump drive |
Note| t | Before removing, set No. 1 cylinder to TDC. |
| t | Mark position of camshaft pulley relative to camshaft housing before removing → Chapter. |
| 4 - | Bolt |
| q | 20 Nm |
| 5 - | Cylinder head |
| q | Removing and installing → Chapter |
| 6 - | Coolant pump |
| q | Removing and installing → Chapter |
| 7 - | Gasket coolant pump housing / thermostat housing |
| q | Observe proper seating of gasket → Fig.. |
| 8 - | Thermostat housing |
| q | Removing and installing → Chapter |
| q | Observe tightening sequence when tightening to coolant pump → Fig.. |
| 9 - | Bolts |
| q | 12 Nm |
| q | Observe tightening sequence → Chapter. |
| 10 - | Gasket between thermostat housing and coolant pump housing |
| q | Observe proper seating of gasket → Fig.. |
| 11 - | Thermostat |
| q | Removing and installing → Chapter |
Note
|
|
|
|
|
