Volkswagen Workshop Service and Repair Manuals > Up! > Power unit | 3 cyl. injection engine, toothed belt drive (4 valves) | Enginecrankshaft group, pistons | Cylinder block, gearbox end | Removing and installing sealing flange on gearbox side | Press sender wheel onto crankshaft flange using assembly toolT10134

Press sender wheel onto crankshaft flange using assembly toolT10134

Press sender wheel onto crankshaft flange using assembly tool -T10134-

–	Tighten hexagon nut of assembly tool -T10134- with torque wrench -V.A.G 1331- and tool insert AF 24 -V.A.G 1332/11- to 35 Nm.

Note

After hexagon nut is tightened to 35 Nm, a small air gap must still be present between cylinder block and sealing flange.