Volkswagen Workshop Service and Repair Manuals

Removing and installing Lambda probe after catalytic converter -G130- Special tools and workshop equipment required

t  Tool set, 17 mm -T10395-

t  Lambda probe open ring spanner set -3337-

t  Torque wrench -V.A.G 1331- Removing

–  Unlock and disconnect connectors above lambda probe after catalytic converter -G130--arrow-. Steckerfarbe schwarz -  Lambda probe -G39- Steckerfarbe braun -  Lambda probe after catalytic converter -G130- –  Remove wiring harness from guides.

–  Unscrew lambda probe after catalytic converter -G130--1- from catalytic converter -2- from below. Installing Install in reverse order. In the process, note the following: Grease only the threads with „G 052 112 A3“; „G 052 112 A3“ must not get into the slots on the probe body. If seal is leaking, nip open and renew.

Specified torque:

Component	Specified torque
Lambda probe after catalytic converter -G130-	50 Nm