| If a transceiver is retrofitted in the vehicle, the battery is used to connect the positive and negative wires. |
| In addition, the wiring harness must be manufactured: |
| t
| Positive voltage supply via a red wire with 2.5 mm2 cross section. |
| t
| Negative voltage supply via a brown wire with 2.5 mm2 cross section. |
| The positive wire must have a fuse located in the immediate vicinity of the battery. For this purpose, a fuse holder must be secured next to the battery. Both wires must be enclosed in an insulating tube. |
| Appropriate connections must be attached to wires on the battery side. |
| Proceed according to unit's operating instructions on side of unit. |
| The additional wiring must be routed separately from vehicle wiring, and a distance of at least 10 cm must be maintained. |
Note | t
| When laying the wiring, ensure that wiring is not routed parallel to factory wiring. |
|
|
|
