760 L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1985)
Remove the circlip (left arrow) and the two nuts (right arrows) for the pressure actuator.
Remove the actuator from the bracket
Remove the old drain pipe from the engine block
NOTE:
Be sure the old seal ring (arrow) in the block comes out with the drain pipe.
Check and clean the sealing surface for the drain pipe gasket on the turbocharger
Install new seal ring (arrow), P/N 1306264-1, on new drain pipe, P/N 1326253-0. Lightly grease the new seal ring.
Guide drain pipe into hole in engine block and make sure the seal ring seats properly.
Holding the drain pipe in position at the turbocharger, reinstall the pressure actuator in the bracket and the two actuator nuts (arrows).
