760 L6-2383cc 2.4L DSL Turbo D24T (1983)
M10.Install brake disc
Ensure that mating surfaces on hub and disc are clean.
Install disc with marking as close to hub marking as permitted by wheel studs.
Note: Hub markings may differ. Insert locating stud and tighten to 8 Nm (6 ft. lbs.).
M11.Install brake caliper
Use new bolts. Tighten to 100 Nm (74 ft. lbs.).
M12.Press back caliper pistons
Press back pistons slowly and carefully using universal pliers, taking care to avoid damage to dust seals. Ensure that seals are slightly inside piston
ends to prevent damage from pad backing plates when caliper is lowered into position.
M13.Install brake pad
Lubricate pad backing plates with thin coating (0.1 - 0.2 mm) of silicone grease, P/N 11 61 325-4.
Note: This applies only to Bendix (DBA) calipers. Pad backing plates on Girling calipers are provided with rubberized anti-squeal coating. Lower
caliper into position.
