850 L5-2.3L Turbo VIN 57 B5234FT (1994)
Install knock sensors (KS) and tighten to 20 Nm (15 ft. lbs).
Note:
Tighten front knock sensor (KS) in the three o'clock position and rear knock sensor (KS) in the five o'clock position.
Install bracket with adapter wiring on the engine wiring duct.
Route the cable from the knock sensors (KS) and the two existing cables under the starter motor bracket to the cable duct.
Note:
Check the cable color markings so that they are connected to the correct connector on the adapter wiring.
Clamp the connectors and wiring to the cable duct with two tie straps as illustrated.
Installing Intake Manifold
Install:
-
New gasket with manifold lower bolts (four).
-
If equipped: Crankcase ventilation hose to intake manifold at servo pump.
-
All: Intake manifold.
