850 L5-2.3L Turbo VIN 57 B5234FT (1994)
-
Knock sensor (KS) connectors
-
Knock sensors (KS)
Replace cable terminals and receptacle housings
Replace cable terminals and receptacle housings on cables from engine compartment cable harness to knock sensors (KS).
See Service Manual "Wiring repairs and replacement of cable terminals" 850, 900 sections DD, EB, FA, FB, GB, GC, GD, J.
Note:
Ground cables (two-tone) should be connected to position 2 in the receptacle housing.
Pull the shorter cable (to the rear knock sensor (KS)) out of the protective sleeve so that it reaches the engine wiring duct.
Note:
The knock sensor (KS) cable should be routed under the starter motor/starter motor bracket.
Tape the ends of the protective sleeve where the rear knock sensor (KS) wiring emerges.
Install protective sleeve on wiring.
Cut to the correct length. Protective sleeve is available by the meter.
Install bracket, adapter wiring and clip as illustrated.