850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
The three screws and two nuts from the drive gear.
-
The drive gear from the slide rail.
Install:
-
The drive gear.
Note: When installing the drive gear, make sure that the toothed shaft of the drive gear is inserted in the hole in the sliding block on the slide
rail.
-
Check that the slide rails are in the same position.
Note: The slide rails must be in the same position, otherwise the seat will not fit into the car.
-
Drive unit and slide rail.
Apart from this, the components are installed in the reverse order.
-
Activate the mechanical belt tensioner. See: Service and Repair/With Power Seat/Deactivating/Activating the Mechanical Belt Tensioner
