850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
6. Install end cover in pump housing. Press end cover into pump housing. Install snap ring (circlip).
NOTE: Take care to align scribed marks with each other as illustrated.
7. Install pump shaft and bearing:
a. Push shaft into pump Housing until bearing reaches stop.
b. Install snap ring (circlip) with rounded side facing upward towards drive pulley.
8. Install control valve. Install:
-
O-ring on nut.
-
Spring.
-
Control valve.
-
Nut. Tighten to 75 Nm (55 ft. lbs.).
9. Install drive pulley. Grease pump shaft, then press on pulley. Use press tool. Press until nut meets end of shaft.
