850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Power Steering Pump: Service and Repair
Replacement
Tool Required
^
999 5443 Puller
^
999 5444 Press Tool
Removal
1. Drain off approximately 3 liters of coolant. Drain cock is located at left-hand side of car under radiator.
2. Disconnect coolant hose from thermostat housing.
3. Disconnect:
a. Fluid hose clip from dipstick tube.
b. Cooling air hose to control module box.
4. Remove drive belt from pump. Use 3/8" ratchet or similar tool to relieve tension on automatic belt tensioner. Remove belt.
5. Remove guard plate bolt and spacer sleeve.
6. Slacken pressure hose union 1/4 turn.
7. Slacken guard plate lower mounting nut a few turns.
8. Remove pump mounting bolts as follows:
a. 3 bolts through drive pulley holes.
b. 2 bolts on left-hand side.
9. Lift pump straight upward:
a. Collect spillage fluid, if any, in a small container.
b. Disconnect pressure hose from pump. Remove original O-ring.
c. Carefully make small cut in return hose to free from connection branch.