C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Install:
-
the trigger wheel
-
the camshaft position (CMP) sensor housing and a new cover
-
the intake air hose between the turbocharger (TC) and the air cleaner (ACL) cover
-
the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for motor bracket
-
the negative battery cable. First read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Checking the engine
Test drive the car to check the function of the engine.
Replacing the rear seal
The following components must be removed when replacing the rear seal:
-
the cross stay between the suspension turrets
-
the air hose from the air cleaner (ACL) to the turbocharger (TC). Place to one side. Seal the openings
-
place the air cleaner (ACL) cover to one side
-
the charge air pipe over the engine. Seal the openings
-
the cover over the ignition coils
-
the upper torque rod bracket
-
the camshaft position sensor (CMP) housing and trigger wheel.
Replacing the rear camshaft seal
