C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
It is extremely important that there is no thread sealant residue or other dirt. This could cause leakage.
NOTE: To clean the crankshaft, use cloth 9511024.
Installing The Sealing Ring
CAUTION: Only Volvo approved engine oil may be used. Grease must not be used at all. It attracts dirt and results in the build up of coke.
-
Lubricate the sealing ring mating surface against the cylinder block and the lips of the seal.
CAUTION: Hold the drift straight when installing so that the sealing ring is pressed in to the same depth all the way around, reducing the
likelihood of leakage.
-
Thread the seal onto the beveled part of the inner section of 999 5676 with the felt side of the seal outwards
-
Install the drift on the crankshaft
-
Tap in the seal using the outer section of drift 999 5676. Use handle 999 1801. The seal is in position when the outer drift bottoms out against the
inner drift.
Installing Flywheel And Carrier Plate
CAUTION: Ensure that the surface of the crankshaft and the mating surfaces for the flywheel/carrier plate are clean. Ensure that there is no thread
sealant residue in the screw holes.
Install:
