C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
When Replacing The Front Crankshaft Seal
-
Remove the old seal using a groove-cut chisel or: 999 5919.
-
Clean the mating surface.
-
Grease and install a new seal. Use tool 999 5455.
-
Press in the seal using a drift and the crankshaft center nut as shown in the above figure.
NOTE: Check thoroughly that the crankshaft does not rotate when pressing in the crankshaft seal.
Remove The Oil Pump
-
Remove the four oil pump screws.
-
Remove the oil pump.
-
Use a groove-cut chisel and carefully break at the stop lugs.
-
Clean the gasket face and the mating surfaces.
Install The Oil Pump