C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Check bearing wear, Replace if necessary.
-
Idler pulley:
-
Spin the idler pulley and listen for noise.
-
If replacing with a new idler pulley, tighten to 24 Nm (18 lb.ft).
-
Tension pulley:
-
When replacing, screw the tension pulley into place with the center screw.
-
Screw in the center screw by hand.
-
Ensure that the tensioner fork is centered over the cylinder block rib.
-
Ensure that the Allen key hole on the eccentric is at 10 O'clock.
As shown in the above figure.
Installing The Camshaft Belt
Install The New Belt As Follows: