C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
Install the screws (1, 3). Tighten to 50 Nm.
-
Install the screw and nut (2) for the torque rod.
-
Tighten to 40 Nm. Angle-tighten 40 degree.
-
Use bevel protractor 951 2050.
NOTE: Use a new screw and nut.
Installing the ball joint on the wheel spindle
-
Check that the groove on the ball joint spindle lines up with the screw hole in the wheel spindle.
NOTE: Press the ball joint upwards so that the conical top is visible above the screwed joint on the wheel spindle.
-
Use a new locknut in the wheel spindle screw.
