C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Position mobile jack 998 5972 against the oil trough.
NOTE: Use a wooden block as a shim.
Lift the engine to access the control arm screws.
Remove:
-
the four screws (1) for the control arm
-
the control arm.
Installing the control arm on the left-hand side
NOTE: Ensure that there is no exhaust leakage.
-
Install the control arm on the sub-frame. Use new screws. Tighten to 65 Nm. Angle-tighten 90 degree. Use bevel protractor 951 2050.
-
Lower and remove the mobile jack.
Installing the control arm on the right-hand side
-
Install the control arm on the sub-frame. Use new screws. Tighten to 65 Nm. Angle-tighten 90 degree. Use bevel protractor 951 2050.
-
Lower and remove the mobile jack.
Installing the engine mountings
-
Install the two screws (1) for the engine pad on the right side. Tighten to 35 Nm. Angle-tighten 90 degree.
-
Use bevel protractor 951 2050.
NOTE: Use new screws.