S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Steering Gear: Removal and Replacement
Steering gear housing, replacing
Removal
Removing the steering gear housing from the steering column
Remove:
-
the floor carpet on the driver's side
-
the tie strap from the intermediate plate
-
the screw from the pinion shaft.
Align the car wheels so that they are straight. Lock the steering wheel lock.
Removing the ends of the ball joint
Raise the front end of the car.
Remove:
-
the right front wheel (only applies to left-hand drive cars)
the left front wheel (only applies to right-hand drive cars)
-
the ends of the ball joints for the tie rods from the wheel spindles. See Ball joint tie rod, protective bellow or tie rod, replacing See: Tie
Rod/Service and Repair/Removal and Replacement
-
the cross stay and the central front-rear member.
Removing the front exhaust pipe
Remove the front and rear heated oxygen sensors (HO2S). See Replacing lambda sonde front See: Powertrain Management/Computers and Control
Systems/Oxygen Sensor/Service and Repair/Removal and Replacement and Replacing lambda sonde rear See: Powertrain Management/Computers and
Control Systems/Oxygen Sensor/Service and Repair/Removal and Replacement.
Remove the front exhaust pipe. See Exhaust pipe front/catalytic converter, replacing See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair/Removal and Replacement/Exhaust Pipe Front/Catalytic Converter, Replacing.
Remove:
