S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
The ball joint on the tie rod.
If the boots are on the right-hand side.
Install:
-
the clamp (2) on the steering gear housing
-
the heat deflector on the steering gear housing
-
the mounting screw for the heat deflector
-
the heat shield at the cowl panel.
When replacing the right-hand tie rod
Install the support so that it is secure. Tighten to 25 Nm. Install both brackets on the support. Tighten to: M6 screw 10 Nm, M8 screw 15 Nm.
Installing the ball joint on the tie rod
(Count the number of turns)
Install:
-
the ball joint for the tie rod in the wheel spindle
-
the castle nut/lock nut. Tighten to 24 Nm.
If applicable, install the split pin. Only tighten the castle nut further if required to insert the split pin. Check the toe-in. See: Alignment/Service and
Repair
Installing the front wheel (right-hand tie rod)
Install the front wheel.