S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Raise the car
-
Remove the rear wheels.
-
Carefully drill out the rivets that hold the mudguard in place on both sides. Use a dia. 6 mm (1/4") drill bit
-
Remove the mudguards.
Illustration 7B applies to all cars
-
Screw the screw (1) almost all the way out on the left and right hand sides in the rear edge of the wheel arch
-
Press the screw using a screwdriver. This is so that the loose ends on the inside of the bumper cover are pressed backwards
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a dia. 6 mm (1/4") drill bit. Ensure that no plastic parts are damaged.
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it
detaches completely
-
Place the bumper on a suitable underlay that will not damage the paint.
Remove:
