S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
the screws (3) on the bracket
-
the bracket by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the rear right side of the car The bracket will not be used again.
-
Apply masking tape (1) to the outside of the bumper to avoid damage from the saw. Install masking tape opposite where the cutting will occur and
over the bumper cover as illustrated
-
Leave the masking tape in place throughout the installation procedure
-
Saw according to the markings on the inside of the bumper as illustrated
-
After cutting, even off the edges using a file.
Installing the fixed tow hitch (including the cable harness)
-
Clean any underseal and dirt from the mating surfaces between the tow hitch cross member (1) and the car body
-
Install the screws (2) (length = 110 mm (4 5/16")), (3) (length = 70 mm (2 3/4')) and (4) (length = 50 mm (2")) from the underneath and the
washers (5) between. Loosely tighten.
-
Install a washer (6) on the left-hand side on the front of the screws (4). This is to secure the rear mounting for the heat deflector plate using the
screw (7).
-
Tighten the screws (2) Tighten to 120 Nm (90 ft.lb.). Tighten the screws (3, 4). Tighten to 90 Nm (68 ft.lb.), on both sides.
