S60 2.4 L5-2.4L VIN 61 B5244S (2001)
NOTE: Wheel sensor cables are twinned pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in the
same way when they are reinstalled in the connector. The cables must be twisted 3 times per 100 mm.
Connector terminal numbering is illustrated opposite.
The first and last terminals in the outer smaller rows are marked 1 and 7 and 17 and 23.
The first terminal in the middle row is marked 10.
The large terminals are marked 8 and 9 and 24 and 25.
The diagram below shows where in the connector each wheel sensor should be connected:
When splicing is complete
Install the cable terminal in the connector.
Remove the next cable terminal if several are being replaced and proceed as above.
NOTE: (Only one at a time!)
