S60 2.4 L5-2.4L VIN 61 B5244S (2001)
When all damaged cable terminals have been replaced, secure the cable harness as before using new tie straps.
Lock the secondary lock of the cable terminal by pushing the catch (in the shaded area) in the direction of the arrow using a screwdriver.
Checking wiring and terminals in connector
When replacing the connector it is important that cables are properly connected in the new connector. Check the cable connections before connecting the
control module.
-
Ignition off
-
Connect adapter 951 1354 to the control module connector (cable side).
-
Connect breakout box 981 3190 to the adapter
-
The control module must be disconnected
-
Take readings according to the following table Signal specification, ABS/DSTC (dynamic stability and traction control) control module.