S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! The tape must cure for 24 hours at a minimum of 20°C (68°F) before painting.
-
Install the foam covering on the underside of the spoiler, in the oval depression
Spray paint according to "Touch up spraying".
-
Take the sheet containing the drilling templates from the kit. Cut out the drilling templates.
Illustration A
-
Position the left and right-hand drilling templates against the rear corners of the boot lid. See the illustration
-
Ensure that the templates exactly cover the edges of the boot lid. Loosely secure the templates using tape
-
Measure the distance between the hole markings on the cardboard templates. Use a soft tape measure that follows the shape of the boot lid. The
distance between the hole markings must be 1063.2 mm (41 55/64").
Note! The radian measure must be measured.
-
If the distance is correct: secure the drilling templates firmly using tape.
Illustration B
