S70 L5-2.4L VIN 61 B5244S (2000)
Verification
Hint: After carrying out the repair check that the fault has been remedied as follows:
-
Ignition off.
-
Reconnect connectors, reinstall components.
-
Ignition on.
Activate the indicator LED
The indicator LED should come on.
Fault Tracing Information
Fault Tracing Information
Condition
-
No diagnostic trouble codes (DTCs) stored
Possible source
-
Defective movement sensor.
Checking Movement Sensor Function
Checking Movement Sensor Function
-
Ignition off.
-
Remove the key from the ignition switch.
-
Close all the doors including hood and tailgate.
-
Open driver's door window completely.
-
Lock the car using the remote control to arm the alarm.
-
Wait approximately 25 seconds (so that the alarm goes into monitoring mode).
Lean into the car and wave your arms.
NOTE: Be prepared to deactivate the alarm by unlocking the car with the remote control. The audible acknowledgment signal is very loud.
The alarm should be triggered - it should produce audible and visible alarms.
Is the function OK?
Yes
-
Test complete
No
-
See: Checking Movement Sensor/Replacing Component
