S70 L5-2.4L VIN 61 B5244S (2000)
^
Inspect brake fluid reservoir, level sensor, non-return valves and seals.
Use new seals if necessary.
Clean carefully any components not being replaced of old brake fluid and dirt using new brake fluid.
Installing brake fluid reservoir
Check that there is no dirt in the connections.
^
Grease O-rings and any hoses with brake fluid or glycerine.
Note: Do not use cleaning solution for greasing hoses. Use brake fluid or glycerine.
Install:
^
Brake fluid reservoir from directly above.
^
Bolt on underside of brake fluid reservoir. Tighten to 3.5 Nm. Fill brake fluid reservoir with new brake fluid. In cars with manual transmission:
Connect hose to brake fluid reservoir. Remove hose pliers. Bleed clutch if necessary and check level in brake fluid reservoir. Use genuine Volvo
DOT 4+ brake fluid when topping up.
Finishing
^
Connect connector to brake fluid level sensor.
^
Check that there are no leaks. Clean up any brake fluid spillage with lukewarm water and car-wash shampoo.
Replacing EBD pressure switch
Preparations
Clean around EBD pressure sensor connection to master cylinder.
Put rags under the EBD pressure sensor to protect painted surfaces against brake fluid spillage.
Get a drain bottle and hose to collect brake fluid in.
Removing EBD pressure sensor
