S70 L5-2.4L VIN 61 B5244S (2000)
Clean off any brake fluid spillage with lukewarm water and car-wash shampoo.
Installing wheels
Make sure that brake disc and rim contact surfaces are clean.
^
Grease hub center rim guide with anti-rust agent 116 1038-3.
^
Re-fit wheel.
^
Tighten nuts hand tight. Then tighten in a star pattern to 110 Nm. If tightening with a nut wrench, use torque bracket.
Note: Tightening nuts in a star pattern to a specified torque is important to prevent stresses arising in the brake disc.
Replacing and cleaning brake fluid reservoir
Preparations
Clean around brake fluid reservoir cap, connections between reservoir and master cylinder and any hose connections to prevent dirt entering brake
system. Put rags under the hydraulic unit to protect painted surfaces against brake fluid spillage.
Removing brake fluid reservoir
Ignition off.
^
Disconnect connector from brake fluid level sensor.
^
Drain brake fluid reservoir.
Remove:
^
Bolt from underside of brake fluid reservoir.
^
Brake fluid reservoir from master cylinder.
^
Block hose to clutch cylinder with hose pliers.
^
Disconnect hose from brake fluid reservoir and plug connections to prevent dirt entering system.
Cleaning and checking