S70 L5-2.4L VIN 61 B5244S (2000)
Install:
-
the brake shoes
-
the spacer and the small return spring on the brake shoes.
Installation brake components, continued
Install:
-
the lower mounting spring. Press in the spring. Pull it sideways slightly until it locks
-
the upper mounting spring. Check that the brake shoes are in the correct position in the expander
-
the return spring by the expander.
Check that the mounting springs are secure.
Install the brake disc and the locating pin
Tighten locating pin. Tighten to 8 Nm.
Check the brake pads. Replace if necessary
See Brake pads, rear, replacing.
Install the caliper holder and the brake caliper
Press the brake pads in the caliper apart. Install the caliper holder and the brake caliper.
Tighten the caliper holder mounting screws. Tighten to 60 Nm.